![]() ![]() Go to next machine and follow steps 8 to 13.Test by Opening Cover, Enter PIN1, Enter 1.Follow directions below to set each door.Press “SEND” once to test system and start your door moving.Press “SEND” 2 times for your system to grab your frequency and code it in.Enter your PIN number after pressing the Learn Code button described above, while the motor head indicator light is blinking.When pressed, a radio signal indicator will start blinking red for 30 seconds. This small black button is located behind the light lens at the motor head and is nearest the floppy 6 inch antenna wire that protrudes from the power head. Gently press and release the Receiver Learn Code button on the Power Head Receiver of your Genie Garage Door Opener (Genie motor on the ceiling). To access, press inward, under the number pad lip while sliding downward to expose the battery. Check the 9 volt battery under the keypad numbers. Note: if red indicator light does not blink, it is not taking the programming steps. Enter your Personal Identification Number (PIN).Open cover fully by sliding keypad cover up until it latches.To Program the Intellicode Wireless Keypad Indicator light will blink once and go out. Press and hold “PROG” and “8” while fully opening cover.GWKIC, ACSDG, Two Part, Step-By-Step Programming Model 1: Intellicode Model GWKIC, ACSDG ( black with slide-up cover and the word “Intellicode” printed on the cover) Genie Wireless Intellicode Keyless Entry Pad Programming: 3 Models Test Keypad by sliding cover up until it latches.Enter Door Code, as determined from the chart above, and press the “star” key.Your PIN number can be created from any group of numbers up to 8 digits of your choice. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |